Instruction manual
Connecting to TCH A2 infrared heater1. Infrared heater and control unit are designed to connect to the AC mains with 220V single-phase voltage (allow
ENGLISH5. After the unit is connected, switch 1 on the control unit must be switched ON (see Fig. 5), place the top cover of the control unit back and
9. OPERATING AN INFRARED HEATER BY THE REMOTE CONTROL UNIT (g. 2, g.3)1. ProgrammingPrior to the rst use of an infrared heater by the remote contro
ENGLISH2. Switching onPress ON/OFF button, symbols will be shown on the remote controller's display and POWER indicator will ash on the control
4.3. To conrm the selection, press « » button in 5 seconds after adjust time, then a sound signal will be made and timer will be activated, an
TMS 08.CH TCH A1N, TCH A2 !
. - ,
Рис. 118www.timberk.com 38135
6. .
Dear Customer!Thank you for your good choice and purchase of a remote control unit for a Timberk infrared heater. It will serve you longTMS 08.CH mode
()(. 3) ,
1. LCD- , .2. « »
7. 1. 1 2. 13. - 1 .4.
4. 1,5 2 ,
24www.timberk.com Рис. 11Рис. 12 : TCH A
25www.timberk.com - ,
9. (. 2, . 3) 1. .
3. . 3.1. TCH A23.1.1. «HEAT»3.1.2.
5. . «ON/OFF», .10.
EEC 89/336, -
2. PRECAUTIONSA number of precautions is to be observed upon operation of an infrared heater and a remote control unit. Improper operation as a result
* , , \ \ .
812. . !Timberk,
. Timberk
TimberkTimberk24а
35www.timberk.com
ÀÂ71www.timberk.com
For a more detailed description of technical parameters and characteristics go to www.timberk.ru or ask TIMBERK ocial dealers.5. DIMENSIONAL FEATURES
ENGLISH6. Description of the remote control unitThe remote control unit consists of a control unit and a remote controller.Control unit (Fig. 2)12341.
Remote controller (g. 3)The remote controller should be directed to the signal receiver, located on the control unit. The control unit conrms receip
ENGLISH1. LCD-displayTimer's time value and symbols of unit operation and functions are shown on the display.2. « » ButtonIt is u
7. SCOPE OF DELIVERY1. Control unit 1 pc.2. Remote controller 1 pc.3. Operation manual and guarantee card 1 pc.4. Packing 1 pc.NOTE:To improve
ENGLISHConnecting to TCH A1N infrared heater1. Infrared heater and control unit are designed to connect to the AC mains with 220V single-phase voltage
Comments to this Manuals