Timberk THU UL 06 User Manual download pdf (Page 3)

1. Sprayer

2. The handle of the water tank

3. Water tank

4. Filter cartridge with ion exchange resins

5. The base under the tank for water

6. Ultrasonic membrane

7. Handle adjust the intensity of the steam

8. The handle on / off

9. Power indicator

10. Indicator of lack of water

Sprayer rotates 360 °, the direction of spray vapor is adjusted manually by

the user.

COMPLECT

1. Humidifier 1 pcs.

2. User manual 1 pcs.

3. Warranty card 1 pcs.

4. Carton box 1 pcs.

Fig. 2

www.timberk.ru  ultrasonic humidifier

4. PARTS DESCRIPTION

Fig. 1

1 2

Po wer

Low water

109

ATTENTION!

To avoid electric shock, before you disassemble the unit (take off

the tank), unplug the appliance!

Do not fill the tank other liquids, except for tap water.

Another of the liquid is harmful to internal components and leads

to failure.

Do not fill the device or reservoir for water additives such as

essential oils, fragrances, detergent, chemical medicines, warm

water (above 40 °), etc.

Otherwise, the water tank and the internal parts damaged and

the device will come to a fault.

Do not pour water directly into the interior of the device or

nebulizer.

The presence of water inside the unit may cause damage to the

device.

Do not hit or throw a water reservoir. It may be damaged, leading

to water leakage. Do not use the device in the event of a severe

blow tank.

ENGLISH

7. CLEANING YOUR ULTRASONIC HUMIDIFIER

The method of keeping clean:

Using purified water

Cleaning the base of unit, water tank and ultrasonic transducer every week

Always change to use clean water.

Always drain the water tank when not in use.

Clean all parts of the humidifier before storing by wiping with a damp cloth,

and buffing with a dry cloth.(Except for the electrical control when the unit is

off, any part of the humidifier may be wiped with a soft damp cloth, and

buffed with a dry cloth ,ensuring the unit is unplugged.)

The methods of cleaning the connector:

To clean the dirty surface with a soft brush.

Rinse the transducer with clean water.

The methods of cleaning the base of unit:

Clean the dirty flume with soft cloth.

If there is dirty on the surface of the protective switch of water line, using soft

brush to clean.

Wash the flume with clean water.

ATTENTION!

In order to avoid deformation and erase the working surfaces, leading

to reduced sputtering or other problems, do not use wire brushes,

talcum powder or blades to wipe the nozzle surface.

When strong shocks the water tank can leak.

When the water leaks immediately discontinue operation of the unit

and contact your dealer.

To maintain the unit in a dry state to remove the water after cleaning

and be sure to dry the water tank and the enclosure.

Make sure that inside the water tank and the enclosure is left of water.

Before long a pause in the use of the device dry reservoir and surface of

the device, install the tank in the housing and pack the humidifier

in a plastic bag and then into the box.

Keep the instrument in a room with low humidity.

Storage device in unseasoned state leads to mold.

www.timberk.ru  ultrasonic humidifier

5. OPERATION

Connect the device to the mains. Pre-fill the tank with water.

Before filling the tank with clear dispenser tank. If you do not, by turning the

tank, spray drops. Without the spray device can not operate. When you

move the humidifier does not grasp the handle of the tank. Necessary to

hold the damper at the base.

1. Remove the sprayer, and then the water tank from the device.

2. Grasp the handle on the tank and pull it up.

3. Unscrew the tank counterclockwise.

4. Fill the tank with water.

5. Screw the lid on the tank clockwise.

Make a tight lid lock tank. Make sure that the rubber ring is installed on top

of the tank. Tighten the lid clockwise.

Incomplete implementation of the above measures lead to ingress of air

into the water tank and as a result of a malfunction.

6. Set the tank and spray on the device.

To turn the unit on, turn knob (8) the right to On.

Then turn the knob of the intensity output pair (7) clockwise until it stops

(maximum capacity). After about half a minute the device should go for

maximum performance in moisture.

To control the intensity of the steam turn the knob (7) to the left and right.

To turn the unit off, turn knob (8) in the left to Off.

6. THE FILTER CARTRIGE

The complete set includes a filter cartridge with an ion exchange resin. With

prolonged use, without changing the pitch damper on the appliance and on

subjects close to him may appear white precipitate.

The white precipitate - is calcium and magnesium, which are part of normal

tap water. In developing the resource, the resin in the filter they are released

with the steam and settle on the surrounding objects and surfaces.

Although these substances are safe for people in large numbers they may

have an adverse impact on the furniture.

With the help of ion exchange filter that is installed on the bottom of the

tank, calcium and magnesium are removed from tap water.

At the beginning of the ion exchanger can be painted in water color of tea.

This does not affect safety or operation of the device.

Ion exchanger is installed at the bottom of the tank.

To acquire the ion exchange filter, contact your dealer.

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Timberk THU UL 06 User Manual Page 3

Comments to this Manuals

Related products and manuals for Humidifiers Timberk THU UL 06